Attach a ground wire from one of the threaded studs (A) at the bottom of the housing, to the mounting plate (B). The ground resistance between all system parts shall be < 0. Power from factory ground must be installed by a qualified electrician. Each DISTRIBUTION BOX and controller must be grounded. Grounding of the units: Attach a ground wire from one of. Grounding is a mechanism to protect distribution equipment and people under normal operating conditions, abnormal operational (overcurrent and overvoltage) responses, and hazardous conditions such as shocks. Whether you're a seasoned pro or just starting out, this comprehensive guide will give you practical. Which means you run a ground wire, typically 4 AWG copper, to the ground bar in the main panel. While traditionally this has been connected to 2 ground rods, in a new building it is recommended, and often required, that it be connected to an Ufer ground, which is basically a ground rod in the. The grounding system provides a low-impedance path for fault current and limits the voltage rise on the normally non-current-carrying metallic components of the electrical distribution system. During fault conditions, low impedance results in high fault current flow, causing overcurrent protective. The correct connection method of Distribution box grounding wire mainly includes the following steps: 1.
